Westermo TD-32 - Manual (Page 13)

13 6178-2203
Switch 5 (line modulation)
Used saved parameters
(ATF1) V.21; 300 bit/s
(ATF4) V.22; 1 200 bit/s
(ATF5) V.22bis; 2 400 bit/s
(ATF6) V.32bis; 4 800 bit/s
Related
AT-commands
ON
1 2 3 4 5 6 7 8
ON
1 2 3 4 5 6 7 8
ON
1 2 3 4 5 6 7 8
(ATF7) V.32bis; 7 200 bit/s
ON
1 2 3 4 5 6 7 8
(ATF8) V.32bis; 9 600 bit/s
ON
1 2 3 4 5 6 7 8
(ATF9) V.32bis; 12 000 bit/s
ON
1 2 3 4 5 6 7 8
(ATF10) V.32bis; 14 400 bit/s
ON
1 2 3 4 5 6 7 8
(ATF0) Auto detect mode
ON
1 2 3 4 5 6 7 8
ON
1 2 3 4 5 6 7 8
ON
1 2 3 4 5 6 7 8
LED Status Indicators
PWR Full Intensity The modem is functioning normally
Half intensity The modem is in test mode
Occasional flashing with speaker click Power supply problem
1:6, on:off ratio RAM error
On/off with speaker click Modem unable to start
LINE LED lights up when the modem has the line
ANS LED flashes when a ring is detected on the line. The ANS indicator shines
constantly when answering an incoming call and remains lit thereafter
to indicate the modem is in auto answer mode.
REL LED flashes when the modem is in both error correcting and compressing mode.
When the modem is only in error correcting mode this LED is on.
When the modem is in direct or normal mode this LED remains off.
TD Transmitted Data: Displays data received from the local RS-232/V.24 port
RD Received Data: Displays data leaving the modem on the RS-232/V.24 port
RTS Request to Send signal from the DTE
DCD Data Carrier Detect modem signal
DSR Data Set Ready modem signal
Please also refer to AT&C, AT\N, AT&T, ATS0