Westermo TD-32 - Manual (Page 31)

31 6178-2203
&V – Display Current Configuration and Stored Profiles
This command returns the active configuration, the two stored profiles and the first four saved phone
numbers to the terminal.
Example:
AT&V
ACTIVE PROFILE:
B0 E1 L1 M1 N1 Q0 T V1 W0 X4 Y0 &C0 &D0 &G0 &J0 &K3 &Q5 &R1 &S0 &T5 &X0 &Y0
S00:002 S01:000 S02:043 S03:013 S04:010 S05:008 S06:010 S07:050 S08:002 S09:006
S10:014 S11:095 S12:050 S18:000 S25:005 S26:001 S36:007 S37:000 S38:020 S44:020
S46:138 S48:007 S95:000
STORED PROFILE 0:
B0 E1 L1 M1 N1 Q0 T V1 W0 X4 Y0 &C0 &D0 &G0 &J0 &K3 &Q5 &R1 &S0 &T5 &X0
S00:002 S02:043 S06:010 S07:050 S08:002 S09:006 S10:014 S11:095 S12:050 S18:000
S36:007 S37:000 S40:168 S41:195 S46:138 S95:000
STORED PROFILE 1:
B0 E1 L1 M1 N1 Q0 T V1 W0 X4 Y0 &C0 &D0 &G0 &J0 &K3 &Q5 &R1 &S0 &T5 &X0
S00:002 S02:043 S06:010 S07:050 S08:002 S09:006 S10:014 S11:095 S12:050 S18:000
S36:007 S37:000 S40:168 S41:195 S46:138 S95:000
TELEPHONE NUMBERS:
0= 1=
2= 3=
OK
Please also refer to AT\S
\Vn – Result Codes Displayed in One Row
This command displayes all result codes and messages in one row.
The value is saved in S31 bit 0.
\V0 Standard format on result codes in connect phase. (Default)
\V1 The information returned when in connect phase is displayed in one row.
See also ATW,S95
Wn – Connect Message Control
This command controls the format of the CONNECT messages.
The value is saved in S31 bit 2 and 3.
W0 Upon connection, the modem reports only the DTE speed. (Default)
W1 Upon connection, the modem reports line speed, error correction protocol and the DTE speed.
W2 Upon connection, the modem only reports the line speed.
Please also refer to AT&Q