Westermo GS-01 - Manual (Page 52)

52 6195-2201
7.5 GS-01 to GS-01 with Short Message Service SMS
GS-01 in the sending end
AT+CPIN=xxxx Insert PIN number if required
AT+CMGS=”0709999999” After the AT command, type the number to dial
> Hello darling. followed by Enter. Do not forget the “ “.
The cursor will jump to the next line and a > will
appear. Type your message followed by ctrl Z.
+CMGS: no no is the number of SMS that have been sent.
OK
The same procedure is done when a message is sent to a GSM cellular phone.
GS-01 in the receiving end
+CMTI: “SM”,n Indicates that a message have been received
and can be read at location n.
AT+CMGR=n To read what is stored at location n.
+CMGR: ”REC UNREAD”, Message from GS-01.
”+46708888888”,,”00/09/21,
08:38:35-04”
Hello darling. Message from sender.
7.6 GS-01, Dial up when DTR is activated
AT+CPIN=xxxx Insert PIN number if required
AT+CPBS=”SM” Select ADN phonebook memory storage
AT+CPBW=1,”xx”,129 Storage of number to call in the first location in the
current phonebook memory storage.
“xx”= number to call.
AT%D1 Activates automatic dialling of the phone number
stored in the first location of ADN phonebook when
DTR goes from OFF to ON.
AT&W Store active configuration.
It is not possible to send SMS-message with above application.