Westermo GS-01 - Manual (Page 26)

26 6195-2201
+FCLASS – Select mode
This command puts the module into a particular mode of operation (data or fax).
Command syntax: AT+FCLASS=
Description
0 Data
1 Fax class 1
Application to GSM AT+FCLASS=? Test command
GSM to application +FCLASS: (0,1) Done
OK
Application to GSM AT+FCLASS=0 Data mode asked
GSM to application OK Command valid
Application to GSM AT+FCLASS=1 Fax class 1 mode asked
GSM to application OK Command valid
Application to GSM AT+FCLASS? Current value
GSM to application +FCLASS: 1 Command valid
OK
+CR – Service reporting control
This command enables a more detailed service reporting, in case of data incoming or out-
going call. Before sending the CONNECT response to the application, the GSM module
will precise the type of data connection that have been established.
These report types are:
+CR: ASYNC For asynchronous transparent
+CR: REL ASYNC For asynchronous non-transparent
Application to GSM AT+CR=0 Extended reports disabled
GSM to application OK Command valid
Application to GSM AT+CR=1 Extended reports enabled
GSM to application OK Command valid