Welltech SPCI2S Boards - Manual (Page 20)

Section 4 Regulatory Specifications and Declarations
20
4.2.3 FCC Part 68 Statement - USA
This equipment complies with Part 68 of the FCC rules and the requirements
adopted by the ACTA. On the pcb of this equipment is a label that contains,
among other information, an ACTA product-labelling number in the format
US: AAAEQ##TXXXX. If requested, this number must be provided to the
telephone company.
For this equipment the Facilities Interface Code (FIC) may be 04DU9.BN ,
04DU9.DN , 04DU9.1KN or 04DU9.1SN according to configuration of
equipment, and the Service Order Code (SOC) is 6.0N.
A plug and jack used to connect this equipment to the premises wiring and
telephone network must comply with the applicable FCC Part 68 rules and
requirements adopted by the ACTA.
The T1 interface provided on this equipment is classified by the FCC as an
“XD” terminal device (T1 DSX-1 type) and must be connected behind a
registered CSU or PBX.
If this equipment causes harm to the telephone network, the telephone
company will notify you in advance that temporary discontinuance of the
service may be required. But if advance notice isn't practical, the telephone
company will notify the customer as soon as possible. Also, you will be
advised of your right to file a complaint with the FCC if you believe it is
necessary.
The telephone company may make changes in its facilities, equipment,
operations, or procedures that could affect the operation of the equipment. If
this happens, the telephone company will provide advance notice in order for
you to make necessary modifications to maintain uninterrupted service.
To return a board for warranty repair or any other returns, please contact
your Dialogic vendor from whom you purchased the board or Dialogic
Technical Services and Support 1 . If the equipment is causing harm to the
telephone network, the telephone company may request that you disconnect
the equipment until the problem is resolved.
The mounting of the approved unit in the final assembly must be made so
that the approved unit is isolated from exposure to any hazardous voltages
within the assembly. Adequate separation and restraint of cables and cords
must be provided. The final assembler shall provide in the consumer
instructions all applicable customer information.
Telephone companies report that electrical surges, typically lightning
transients, are very destructive to customer terminal equipment connected to
AC power sources. The use of a surge arrestor on the AC line is
recommended.
In order for FCC registration of this product to be retained, all other products
used in conjunction with this product to provide your telephony function must
also be FCC Part 68 registered for use with CTBUS hosts. All Dialogic ® CTBUS
resource and network devices, which are FCC registered, are compatible and
approved for use with each other.
1 See http://www.dialogic.com/support/contact/ for contact information.