Wavetronix Click 201 (1 amp AC to DC converter) (CLK-201) - Quick-reference Guide - Manual (Page 2)

3
Wire the Click 210 circuit breaker
Follow the steps below to add a Click 210 circuit breaker
and switch:
1 Mount the Click 210 onto the DIN rail.
2 Connect power in to the bottom of the module.
3 Connect power out to the top of the module.
4
Wire the Click 230 AC surge
Follow the steps below to install the AC surge protection:
1 Mount the Click 230 onto the DIN rail.
2 Connect the line (hot) wire from the Click 210 to terminal 5
on the IN side of the Click 230.
3 Connect the neutral wire from the AC terminal block or
cord to the terminal marked 1 on the Click 230.
4 Connect the ground wire from the AC terminal block or
cord to the terminal marked 3 on the Click 230.
5 Connect the outgoing and protected neutral wire to the
terminal marked 2 on the Click 230.
6 Connect the outgoing and protected line wire to the terminal
marked 6 on the Click 230.
7 Terminal blocks 3 and 4 are directly connected to the DIN
rail via the metal mounting foot on the base of the device.
There is no need for any additional grounding between ter-
minals 3 and 4 and the DIN rail.