Wavetronix Click 514 (event logger) (CLK-514) - Quick-reference Guide - Manual (Page 2)

3
Use on-device configuration features
Next, use the device’s configuration features to make sure the
Click 514 is wired and working properly. The Click 514 has four
LEDs that monitor device activity and help you select tasks and
operating modes. It also has two banks of LEDs: one of yellow
LEDs that represent submenu 1 and one of red for submenu 2.
Check the LEDs to make sure the device has power.
The Click 514
also has a
push-button,
labeled Mode
Switch, used
for selecting
tasks and
operating modes.
Yellow LEDs
Red LEDs
Multicolored LEDs
Button
Main Menu
Sub Menu 1
Sub Menu 2
LED activity-indicating functions:
Red – Shows device has power
Green – Shows device is transmitting data
Yellow – Shows device is receiving data
The blue LED has no activity-indicating function
4
How to use the push-button to navigate through mode and task menus
Select a task or operation function by navigating through the main menu (multicolored LEDs) and the sub-
menus (yellow and red LEDs) using the push-button as described below:
1 Enter the m 1 ain menu and cycle through it by
holding the push-button down.
2 Release the push-button once the cycle reaches
the desired mode.
3 Press the push-button again to select the mode.
Once selected, the mode will either start running
or the first submenu (yellow LEDs) will start.
4 Hold the push-button to cycle through the first
submenu.
5 Release the push-button once the desired sub-
menu selection is displayed.
6 Press the push-button again to select the func-
tion. The function will now run.
5
Step
Click Supervisor will be used to configure the Click 514. Follow these steps to install and connect to Click
Supervisor:
1 Download the setup file from www.wavetronix.com (under Support).
2 Double-click on the file to run the setup wizard. Follow the steps to install.
3 Manually copy the 514 driver files into the “Program Files\ClickHome\514” directory.
4 Using the DB-9 connector on the front of the module, make a connection between the Click 514 and
the computer.
Continued on next page