Run mode, Reset, Approaches tabs – Wavetronix Click 513 (traffic alert) (CLK-513) - Quick-reference Guide User Manual

Page 4: Output tab, Lanes tab

8,665,113; and Cdn. Pat. Nos. 2,461,411; 2,434,756; 2,512,689; and Euro. Pat. Nos. 1435036; 1438702; 1611458. Other US and international patents pending. Wavetronix, SmartSensor, Click,

Command and all associated logos are trademarks of Wavetronix LLC. All other product or brand names as they appear are trademarks or registered trademarks of their respective hold-

ers. Product specifications are subject to change without notice. This material is provided for informational purposes only; Wavetronix assumes no liability related to its use.

WX-500-0197

Approaches Tabs

There is one sub-tab for each approach under the main Approaches tab. Each

enabled variable for the specified approach will qualify an interval if the de-

tected value exceeds the set threshold.

Over Speed – qualifies if average speed is above set threshold

Under Speed – qualifies if average speed is below set threshold

Over Occupancy – qualifies if occupancy is above set threshold

Under Occupancy – qualifies if occupancy is below set threshold

Over Volume – qualifies if total volume is above set threshold

Under Volume – qualifies if total volume is below set threshold

Run mode

Reset

To reset the Click 513, follow the steps below:
1 Hold the push-button down, then release when the red LED starts flashing.

2 Press the push-button to select. The first yellow LED will turn on to let you use that submenu.

3 Hold down the push button again to cycle between the following options:

Yellow 1 – Resets all settings except Serial Number and XML variable map

Yellow 2 – Resets all settings except Serial Number

4 Release when you reach the one you want. Press the push-button to select.
After the device is reset, it will return to the last mode that it was in.

Once the device has been configured, set it to Run mode to start retrieving traffic data.
1 Hold the push-button down, then release when the blue LED turns on.

2 Press the push-button to select. The red and blue lights will turn on, and the yellow light will flash as

data is received.

In run mode the Click 513 polls data from the SmartSensor HD on the RS-485 T-bus port and compares the

detected values to the thresholds set in Click Supervisor. You can use a serial terminal program to view text

status information on your computer.
Note. The Click 513 communicates at 9600 bps.

Output Tab

Time Zone – Allows you to select the appropri-

ate time zone.

Morning/Afternoon Start/Stop Time – Begin-

ning and end times that the alerts will operate to

turn on/off during the morning/afternoon hours.

Lanes Tab

There is one sub-tab for each lane under the main

Lanes tab. Each enabled variable for the specified

approach will qualify an interval if the detected value

exceeds the set threshold. The settings are the same as

the Approaches tab.