Set up server output – Wavetronix Click 511 (digital I/O repeater) (CLK-511) - Quick-reference Guide User Manual

Page 6

8,665,113; and Cdn. Pat. Nos. 2,461,411; 2,434,756; 2,512,689; and Euro. Pat. Nos. 1435036; 1438702; 1611458. Other US and international patents pending. Wavetronix, SmartSensor, Click,

Command and all associated logos are trademarks of Wavetronix LLC. All other product or brand names as they appear are trademarks or registered trademarks of their respective hold-

ers. Product specifications are subject to change without notice. This material is provided for informational purposes only; Wavetronix assumes no liability related to its use.

Set up server output

The Setup Server Output task allows you to configure fail-safe mode, as well as to select whether the output

is an alarm (inverted) or relay (pass-through).

To change either of these two options, follow the steps below:
1 Hold down the push-button, then release

when the green LED flashes.

2 Quickly press and release the push-

button to select this task. This will start

the first submenu, which allows you to

choose between alarm and relay mode.

3 Use the table to the right to choose between alarm mode and relay mode. In alarm mode, if the digital

output device is open, the server contact closure is closed. In relay mode, if the digital output device is

open, the server contact closure is also open. Hold down the push button until you reach the LED state

for the desired mode, then release.

4 Press the push-button once to select this option. This will start submenu 2, which lets you turn fail-safe

mode on and off.

Note. Because submenu 2 can only be reached through submenu 1, to turn fail-safe mode on or off you

must first select whether to set the device in alarm mode or relay mode.

5 Use the table above to turn fail-safe mode on or off. In this mode, if an input state is persistently undis-

coverable (or has never been discovered), then the output related to this input will enter the fail-safe

state.
In alarm operation, the associated output will be ON in fail-safe mode. In relay operation, the associ-

ated output will be OFF in the fail-safe state. However, if the input state has been recently acquired by

a previous query, then this state will be reported until 10 consecutive timeouts. Hold down the push

button until you reach the LED state for the desired state, then release.

6 Press the push-button once to select this option. The Setup Server Output task is now completed, and

the device will return to the operating mode it was in before the task began.

WX-500-0195

1st LED

2nd LED

Submenu 1 (Yellow LEDs)

Alarm mode

Relay mode

Submenu 2 (Red LEDs)

Fail-safe on

Fail-safe off