Watson-Marlow MM420 - Manual (Page 197)

Issue 10/06 Changing the Operator Panel
MICROMASTER 420 Operating Instructions
6SE6400-5AA00-0BP0 197
Class 3: Filtered - for residential, commercial and trade applications
This level of performance will allow the manufacturer / assembler to self-certify
compliance of their apparatus with the EMC directive for the residential,
commercial and trade applications environment as regards the EMC performance
characteristics of the power drive system. Performance limits are as specified in
the generic emission and immunity standards EN 61000-6-3 and EN 61000-6-1 in
residential.
Table 7-4 Class 3 - Filtered for Residential, Commercial and trade applications
EMC Phenomenon Standard Level
Emissions: Radiated Emissions* EN 55011 Limit B
Conducted Emissions EN 61800-3 Category C1:
Limit complying with
EN 55011, Class B
Category C2:
Limit complying with
EN 55011, Class A
Immunity: Supply Voltage Distortion EN 61000-2-4
Voltage Fluctuations, Dips,
Unbalance, Frequency
Variations EN 61000-2-1
Magnetic Fields EN 61000-4-8 50 Hz, 30 A/m
Electrostatic Discharge EN 61000-4-2 8 kV air discharge
Burst Interference EN 61000-4-4 2 kV power cables, 2 kV control
Radio Frequency
Electromagnetic Field,
amplitude modulated
EN 61000-4-3 80-1000 MHz, 10 V/m, 80%
AM, power and signal lines
Radio-frequency
Electromagnetic Field,
pulse modulated
EN 61000-4-3 900 MHz, 10 V/m 50% duty
cycle, 200 Hz repetition rate
* These limits are dependent on the inverter being correctly installed inside a
metallic switchgear enclosure. The limits will not be met if the inverter is not
enclosed.
NOTICE
To achieve these performance levels, you must not exceed the default Pulse
frequency nor use cables longer than 25 m.
The MICROMASTER inverters are intended exclusively for professional
applications . Therefore, they do not fall within the scope of the harmonics
emissions specification EN 61000-3-2.
Maximum mains supply voltage when filters are fitted is 460 V.