Extron Electronics Matrix 6400 Series - Manual (Page 52)

Extron • Matrix 3200/6400 Series • User’s Manual
Chapter 5 • Upgrades and Troubleshooting
Adding BME(s) to a Matrix 3200/6400 System
Figure 5-9.A Adding BMEs to a Matrix 3200/6400 system
Adding BME(s) to an existing Matrix 3200/6400 System involves doing most of
the same steps as an initial installation. Extron recommends that the following
steps be done in the order listed to add a Video BME (maximum Video BMEs per
system = 3) and/or an Audio BME (maximum Audio BMEs per system = 1) to an
existing system.
1. See Page 5-11 “Software Procedure - Before and After a Hardware Upgrade”.
Do steps under “Before Hardware Changes” before making any hardware
changes.
______ To ignore step 1 and proceed with the hardware upgrade will require considerable
system reconfiguration time. It is highly recommended that you not skip any step.
2. Remove power before proceeding. Go to “Adding a Video and/or an Audio BME”
(below). If this is not a Video or Audio BME add-on, go to Chapter 2.
3. Set the BME address numbers (0 - 5). (Page 2-2)
4. Connect the BME COMM interconnecting cable(s). (Page 2-2)
5-9
AN AH EIM , C A MA DE IN US A
AC P OW ER IN PUT FUS E: 250 V 5 .0A TT
100-240V 0.5A MAX 50/60Hz DISCONNECT PO
WER CORD BEFORE SER
VICING
BM E
AD DR ES S
4
IN OU T BME COMM.
MKP COMM.
A B C D E A B C D E
IN
1 - 8
IN
9 - 1 6 17 - 24 25 - 32 33 - 40 41 - 48 49 - 56 57 - 64
INP UTS
OU TPU TS
RG B MU TE
AU DIO MU TE
RG B MU TE
AU DIO MU TE
Expandable (x 8)
from 64 x 8 to
64 x 64
Expandable to
Matrix 6400 Video
(2) 64 x 64 BME's =
64 x 64 S-Video System
Y Signal
BME (Basic Module Enclosure)
R - Y
Y
C
B - Y
Expandable to
(3) 64 x 64 BME's =
64 x 64 Component System
An Audio BME can easily be added to
any system from 8 x 8 to 64 x 64.
Audio (rear view)
Matrix 3200/6400 Series
Matrix 3200/6400 Se
ries