Extron Electronics Matrix 6400 Series User Manual
Page 40
Extron • Matrix 3200/6400 Series • User’s Manual
Chapter 4 • Programmer’s Guide
Virtual Output MUTES
VM
1
•
2
• • • • •
64
Mut
Notes:
1. Start output is always Ø1 for Room PRESET, because room has max. of 16 outputs assigned.
2. All “VI” values in responses are 2 numeric characters (i.e. 12 or Ø3) or “na” indicating nonexistent
virtual outputs.
3. In “VA” View, any outputs that do not follow show as “- -“ in response.
4. Rvo = Virtual Output assigned to specified “room” (up to 16 total).
RGB D
ELAY
C
OMMANDS
ASCII (H
OST
-S
WITCHER
)
RESPONSE (S
WITCHER
-H
OST
)
Read RGB Delay (for 1 ch.)
D
Out
•Dly
Set RGB Delay (for 1 ch.)
d
*
Out
•Dly
Note: Where
= delay in 1/2 second increments (i.e. Ш = Ш sec, 1Ш = 5.Ш sec)
D
IRECT
W
RITE
OF
G
LOBAL
P
RESETS
C
OMMAND
ASCII (H
OST
-S
WITCHER
)
R
ESPONSE
(S
WITCHER
-H
OST
)
Start Write Mode
P
Write Preset
Ready
End Write Mode
p
End Write Preset
Example
P32
Write Preset 32 Ready
1*1!
1*2&
1*3%
:
:
1*64$
p
End Write Preset 32
Notes:
1. Any non-output switching or invalid command between the Start and End commands will be
ignored.
2. If there is no activity for 5 seconds while in write mode, then error E17 occurs.
3. No front panel switching (Actual Switching) is allowed during the Start and End commands.
4. If an End (
p) command is issued with no Start command, then error E1Ø occurs.
Q
UICK
R
ECALL
OF
G
LOBAL
P
RESET
C
OMMANDS
ASCII (H
OST
-S
WITCHER
)
R
ESPONSE
(S
WITCHER
-H
OST
)
Quick Recall Preset
.
RPR
Notes:
1. If the Quick Recall Preset (
.) command is issued without an active write, then error E1Ø occurs.
2. Complete backplane switch within 6ØmS (apprx.) after receipt of the command.
3. Recall must take place 1ØØmS after End Write Mode command (
p).
4. Quick recall command only recalls last entered direct write preset.
S
ET
N
AMES
C
OMMANDS
ASCII (H
OST
-S
WITCHER
)
RESPONSE (S
WITCHER
-H
OST
)
Read Global preset name
NG
Write Global preset name
nG
,
NamP
Read Room preset name
NP
*
Write Room preset name
nP
*
,
NamP
Read Room Name
NR
Write Room Name
nR
,
NamR
Read Virtual Input Name
NI
Write Virtual Input Name
nI
,
NamI
Read Virtual Output Name
NO
Write Virtual Output Name
nO
,
NamO
Z
AP
C
ONFIGURATION
C
OMMANDS
ASCII (H
OST
-S
WITCHER
)
RESPONSE (S
WITCHER
-H
OST
)
Zap All Global presets & names
zG
ZapG
4-7
A
DVANCED
I
NSTRUCTION
S
ET
AND
S
IMPLE
I
NSTRUCTION
S
ET
C
OMMANDS
(P
AGE
2
OF
3)
V
IEW
C
OMMANDS
ASCII (H
OST
-S
WITCHER
)
RESPONSE (S
WITCHER
-H
OST
)