Extron Electronics Matrix 6400 Series - Manual (Page 49)

Extron • Matrix 3200/6400 Series • User’s Manual
Chapter 5 • Upgrades and Troubleshooting
HI GH V OL TA GE
CA UT IO N
HI GH V OL TA GE
CA UT IO N
Fuse
PO WE R S UPP LIE S
CO MM UN ICA TIO NS
PR IMA RY
TX RS2 32 BM E REM OTE SYS TEM STA TUS
RED UN DA NT
RX DIA GN OS TIC S
+V -V
MA TRIX 6400
VIDEO
H1 20
AC POWER INPUT
FUSE: 250V 0.8A TT
100-240V 0.5A MAX 50/60Hz
Checking/Replacing the BME External AC Input Fuse
The AC power input cord plugs into the Power-Switch/Fuse assembly which is
located on the rear panel in the lower left corner of the BME. To check/replace the
external fuse, remove the power-cord and insert the tip of a small
screwdriver blade into the fuse-holder slot (the fuse-holder is located
just below the power switch). Pry the fuse-holder out, it contains the
AC input fuse plus a spare. If may be obvious that the fuse is blown,
if not, check it with an ohmmeter or any other continuity device if
available. If the fuse is blown, replace it with the provided spare. Plug
the AC power cord in and Power the BME ON. Verify that the unit
powered ON correctly (check Front Panel LEDs). If the LEDs are in
the proper state, the problem has been corrected. If not, contact
Extron Technical Support.
Checking/Replacing the BME Internal Power Supply AC Input Fuses
Each internal power supply has an AC input fuse. If a power supply fuse blows,
the Front Panel LED for that power supply will go OFF (it is normally solid ON). If
the BME has redundant power supplies, the redundant supply for the failed power
supply will assume the full load and its front panel diagnostic LED will blink
indicating that the Main (Primary) power supply is inoperative. To check/replace a
power supply fuse, unplug the AC power cord from the BME rear panel, remove
the Access Panel (see Page 5-2). The power supply fuse location is shown in
Figure 5-6.A (circled). Remove the fuse from the problem power supply. If may be
obvious that the fuse is blown, if not, check it with an ohmmeter or any other
continuity device if available. If the fuse is blown, replace it, plug the AC power
cord in, power up the BME and check Diagnostic LEDs. If the problem persists,
call Extron Technical Support.
POWER SUPPLIES COMMUNICATIONS
PRIMARY TX
RS232 BME REMOTE
SYSTEM
STATUS
REDUNDANT RX
DIAGNOSTICS
+V -V
Redundant V+
Power Supply
would be
located here.
Primary V+
Power Supply
Primary V-
Power Supply
(Redundant V-
would be located
beside Primary
V-)
Figure 5-6.A BME-
Exploded view.
5-6
See note -
Page 5-2.