Extron Electronics Matrix 6400 Series - Manual (Page 45)

Extron • Matrix 3200/6400 Series • User’s Manual
Chapter 5 • Upgrades and Troubleshooting
Matrix 3200/6400 Video BME Internal Access
______ Before opening the BME, turn power OFF and unplug the AC power cord. High
voltages are present inside the BME and the FPC 1000 Front Panel Controller.
Upgrades or repairs may require access to internal areas of the Matrix 3200/6400
Video BME. This involves removing the access panel (blank or FPC 1000) using
a coin or a flat blade screwdriver to rotate the two captive screws (Figure 5-2.A)
as shown in Figure 5-2.B. Pull the top of the access panel out slightly then lift up
and remove it from the front panel. The FPC 1000 will have a cable connecting it
to the Main Controller, unplug the connector.
When done, reverse the procedure to reinstall the access panel
5-2
MATRIX 6400
VIDEO
POWER SUPPLIES COMMUNICATIONS
PRIMARY TX
RS232 BME REMOTE
SYSTEM
STATUS
REDUNDANT RX
DIAGNOSTICS
+V -V
FPC-1000
RGB
MUTE
AUDIO
MUTE
Figure 5-2.A Use a coin or screwdriver to rotate two captive screws.
Captive screws
RG B MU TE
AU DIO MU TE
Figure 5-2.B Removing the access panel (blank or FPC 1000)
See note
above.