Watson-Marlow APEX10 - Manual (Page 56)

SPECIFICATIONS
56
11.1.3 Surface treatment
•
After surface preparation, one layer of two-component acrylate is used for
surface protection. Standard colour is RAL 3011.
•
All galvanised parts have been provided with an electrolytic zinc layer of 15 - 20
microns.
11.1.4 Lubricant table pump
Bredel Genuine Hose Lubricant is registered at NSF: NSF Registration N
o
123204;
Category Code H1. Also refer to: www.NSF.org/USDA.
An alternative lubricant is available based on silicone. Also compatibility with this
lubricant must be checked if applied. Refer to the chemical compatibility chart at
www.wmpg.com/chemical or contact your Bredel representative for guidance.
APEX
Lubricant Bredel Genuine Hose Lubricant
Required quantity [litres] 1.0
Components:
Glycerol (C
3
H
8
O
3
) 50-100% w/w
Glycol (C
2
H
6
O
2
) 2.5-10% w/w
Water (H
2
O)
Consult your Bredel representative if you require additional information with
respect to the safety data sheet.
WARNING
It is the users responsibility to ensure the chemical compatibility of the fluid
to be pumped with the lubricant in the pumphead. Obey the local Health
and Safety regulations.