Watson-Marlow APEX10 User Manual
Page 42
MAINTENANCE
42
7.
Put a plastic or wooden drive pin (A) on the
rotor.
8.
Hit the drive pin firmly with a hammer to remove
the rotor.
9.
Put the hose pump upright on the support.
10.
Dismount the circlip (A) with the correct tool.
11.
Dismount the bearings (A), the spacer ring (B)
and the retaining ring (C) with the correct tool.
Clean the hub.
12.
Remove the seal ring (A). Clean and degrease
the bore. The holes in the pump housing can be
used to drive out the old seal.
A
A
A
C
B
A
A