Verilink SCC 2020 (880-503268-001) Product Manual - Manual (Page 9)

Verilink SCC 2020 User Manual 1-1
Chapter
1
Overview
This User Manual describes the SCC 2020 Node Controller module,
a component of Verilink’s Access System 2000 (AS2000) platform.
The SCC 2020 is an SNMP (Simple Network Management Protocol)
network management module which also functions as a T1 CSU.
Scope This manual assumes you are already familiar with the standard
AS2000 products. Where references are appropriate, the text refers
you to a specific Access System 2000 manual and chapter for
greater detail.
Installation
Information
For information on installing and replacing shelves, modules, and
power supplies, see the manual
AS2000: The Basics .
NOTE: Do not attempt to mix NCM, NCC, and SCC node controllers in
the same node. There can be only one node controller in a
node.
Related Verilink
Documents
Refer to the following related AS2000 manuals:
• SCC 2130 User Manual , documents the SNMP controller
version of the TAC 2130 Integrated T1 DSU/CSU (IDCSU).
• AS2000, The Basics provides general information about
Verilink products.
• The DIU 2131 High-Low Module User Manual documents a
specific application consisting of an SCC 2020 used with a DIU
2131 two-port high-speed / low-speed DSU module.
Features The SCC 2020 SNMP Controller and Channel service unit module
includes an embedded SNMP agent. Adding an SCC module to an
AS2000 node allows network managers to interface their SNMP
Manager with the AS2000 node. This provides full control for
configuration management, performance monitoring, and
maintenance through SNMP Gets, Sets, and Traps.
SNMP Features The embedded agent supports Verilink Enterprise MIBs, and
proprietary MIBs for extended network management functions.
Users can perform SNMP Gets and Sets, as well as receive Traps
when alarm threshold criteria have been met.