Verilink Red Zone Encryption (REMS) (880-502423-001) Product Manual - Manual (Page 65)

Configuring REMS using the thumbwheel switch
Red Zone Encryption Management System (REMS) User Manual 6-5
FBR Thumbwheel Configuration Commands
40 Canned FBR Option 1 (Remote REMS is the
default.)
64 FBR is Master
65 FBR is Remote
68 Disable Re-sync (Default)
69 Re-sync= 2 seconds
70 Re-sync= 4 seconds
71 Re-sync= 6 seconds
72 Re-sync= 8 seconds
73 Re-sync= 10 seconds
80 D4
81 ESF
82 AMI
83 B8ZS
Procedure for
configuring the
BRC Using the BRC thumbwheels (located on the front panel of the BRC NCC
2020), select the BRC timing mode for each BRC in the circuit. Refer to
the subsection, BRC Timing Options, below.
1. Access the BRC by entering its location address into its the
thumbwheel switches (located on the front panel of the BRC NCC
2020).
The STATUS light on the front panel of the NCC begins flashing
Green. (You have 60 seconds to perform the next step.)
2. Using the FBR thumbwheels (located on the front panel of the FBR
NCC 2020), set the FBR to 40. This is the “canned” (preconfigured)
FBR option.
The NCC STATUS light stops flashing.
3. Select the BRC timing mode for each BRC in the circuit. Refer to the
subsection, BRC Timing Options, below.