Configuration menu, Configuration menu -3, Figure 3-1 – Verilink QUAD DATA (880-503319-001) Product Manual User Manual

Page 27

Configuration

Verilink QUAD DATA User Manual

3-3

Figure 3-1 SCM Main Menu

Select QUAD DATA

Module

When you first log in to an SCM controller, the SCM module is
selected. Square brackets indicate the currently selected module

[*S]

[*S]. The prompt line also indicates which module is selected,

A [0.0.0.4] [0,1] SCM >

A [0.0.0.4] [0,1] SCM >.
Use the

S) shelf/slot

command to navigate to another module.

Type “S” and press E

NTER

. At the prompt, type the number of the

slot where the QUAD DATA module resides. (shelf 1, slot 4 in the
node shown in

Figure 3-1

) and press E

NTER

Configuration

Use the C command to access the QUAD DATA Configuration
Menu, as shown in

Figure 3-2

-- VERILINK SCM CONTROLLER : FW Rev 2.05, May 7 1999 14:32:21 --

Site name: Tech Pubs SCM Access level: 2

Site name: Tech Pubs SCM Access level: 2
Managing at NEAR end node [0.0.0.4] Node id: 21

Managing at NEAR end node [0.0.0.4] Node id: 21

<- SLOT ->

<- SLOT ->
SHELF 1 2 3 4 5 6 7 8 9 10 11 12 13

SHELF 1 2 3 4 5 6 7 8 9 10 11 12 13

SHELF 1 2 3 4 5 6 7 8 9 10 11 12 13
0 M [*S] M - D H - - - - - - - -

0 M [*S] M - D H - - - - - - - -

0 M [*S] M - D H - - - - - - - -
1 - - - - - - - - - - - - -

1 - - - - - - - - - - - - -

1 - - - - - - - - - - - - -
2 - - - - - - - - - - - - -

2 - - - - - - - - - - - - -

2 - - - - - - - - - - - - -
3 - - - - - - - - - - - - -

3 - - - - - - - - - - - - -

3 - - - - - - - - - - - - -
4 - - - - - - - - - - - - -

4 - - - - - - - - - - - - -

4 - - - - - - - - - - - - -
KEY: D=QUAD D, I=IMUX, M=M1-3, Q=QUAD T1, S=SCM

KEY: D=QUAD D, I=IMUX, M=M1-3, Q=QUAD T1, S=SCM

S) shelf/slot O) administration

S) shelf/slot O) administration
C) configuration D) diagnostics

C) configuration D) diagnostics

C) configuration D) diagnostics
P) performance/status A) alarm

P) performance/status A) alarm

P) performance/status A) alarm
B) circuit manager I) manufacturing info

B) circuit manager I) manufacturing info

B) circuit manager I) manufacturing info
X) exit this menu

X) exit this menu

A [0.0.0.4] [0,1] SCM >