23 cy, Adjusting the cycles per hour – Venstar T2900 User Manual

Page 65

Page 13.3

Adjusting the Cycles Per Hour

Press the PROGRAM button to leave the Setup screens. If no buttons are

pressed, the display will leave the setup screens after 30 seconds.

PROGRAM

Press

(d1, d, 2 - 6)

The Cycles Per Hour setting may limit the number of times per hour
your HVAC unit may energize. For example, at a setting of 6 cycles
per hour the HVAC unit will only be allowed to energize once every 10
minutes. The Cycles Per Hour limit may be overridden and reset by
pressing the UP or DOWN buttons on the thermostat.

Setup

PROGRAM

MODE

Press the MODE button. While holding
the MODE, press the PROGRAM
button to enter Setup screens.

Press the MODE button repeatedly
until this setup screen appears.

Select the cycles per
hour limit.
d=cycles per hour
limit defeated.
d1=d + defeat 5 min.
compressor lockout.

Note: Press the

MODE

button momentarily
to move through the
setup screens. Press
and hold the

MODE

button to move back-
wards through the
setup screens.