Venstar T2900 - Manual (Page 33)

Page 6.5
PROGRAMMING TIPS
If only the Occupied 1 period is selected in the first programming step ( page 6.2), Occupied 2
& 3 programming steps are skipped. Further , if Occupied 2 is selected, Occupied 3 program-
ming steps are skipped.
If Yes is selected:
If No is selected:
Press
MODE
Select Yes to copy
the previous day’s
program to this day.
Yes
No
Press
MODE
If No is selected, as in previous steps, flashing prompts will appear to input start
and stop times for Occupied 1. If more than one occupied period was selected in
the first programming step (page 6.2), then the cool and heat setpoints, and start
and stop times for each additional occupied period will be prompted.
Select Occupied 1 to run
on this day (On), or not to
run on this day (Off).
Off
On
Selecting Yes, then pressing mode will copy the
previous day’s program. If yes is selected each
time, this routine will repeat.
6
Heat & Cool setpoints for Occupied 1 are the same for every day of the week. If desired,
Heat & Cool setpoints for Occupied 2 & 3 can be adjusted differently for each day of the week.
If the start time is set later in the day than the stop time, the program will run from the
start time to midnight and from midnight to the stop time on the same day. For example: 9pm
start, 8am stop, on Monday. In this example the program will run from 12am Monday to 8am
Monday and again from 9pm Monday to 12am Tuesday.
Unoccupied Operation: The unoccupied settings take effect at all times when: (1) the prog-
ram is on and (2) the current time is outside a preset occupied period. For this reason start
and stop times are not necessary for unoccupied time periods.
If the same start and stop times are programmed for an occupied period, then it will run 24 hours.
If one occupied period starts and stops within another occupied period the lower occupied #
has priority. For example: If Occupied 3 is programmed to be on 24 hours, and Occupied 2 is
programmed to run that day, then the Occupied 2 setting will take over for Occupied 3
between Occupied 2 start and stop times.
After programming for all seven days is complete, press the PROGRAM button to
leave the Setup screens. If no buttons are pressed, the display will leave the setup
screens after 30 seconds. Press
PROGRAM
occupied
1
ON
Tu
We
NO
CO
PY