Upsite 10013 Extended 6 x 24 Brush - Manual (Page 5)

5
Designer & Manufacturer
(888) 982-7800 www.upsite.com
Modification of Extended
Raised Floor Grommets
The KoldLok Extended Raised Floor Grommets can be modi-
fied to seal large and unique openings. The metal filament
channel and Grommet flange may be cut to a desired length.
*IMPORTANT: Never cut metal within the raised floor environ-
ment.
1. Using a hammer (or mallet) and stake, drive one of the
metal filament channels out of the Grommet flange to
the desired length.
2. Mark the desired cut line.
3. Use bolt cutters to cut and snap the metal filament
channel.
4. Crimp the ends of the metal filament channel with pliers
to prevent bristle escape. File any rough or sharp corners
and edges
5. Repeat Steps 1 through 5 for the other metal filament
channel.
6. Mark the empty Grommet flange for cutting. Cut the
flange with a saw.
7. File the cut edge of the flange.
8. Use a hammer (or mallet) and stake to reposition the
metal filament channel in the Grommet so that the end
of the metal filament channel does not protrude from
the end of the flange channel.
Step 1
Step 3
Step 6