Upsite 10013 Extended 6 x 24 Brush - Manual (Page 2)

2
Designer & Manufacturer
(888) 982-7800 www.upsite.com
Designer & Manufacturer
(888) 982-7800 www.upsite.com
Tools and Preparation Required for Installation
Tools Required:
• Bandsaw, table saw, or other appropriate cutting tool
• Hand tools, including bolt cutters, pliers, hammer (or mallet), stake, and metal file
Preparation:
• Remove skirts and tip plates to access the cable cutout.
• Determine the maximum dimensions of the trimmed cutout. To ensure stability and
proper sealing, the KoldLok Extended Raised Floor Grommet should have a minimum
surface-to-floor contact of 1 inch (25mm) on three sides of the cutout. Otherwise, the
Grommet cannot be used to effectively seal the cutout. Contact Upsite Technologies,
Inc. at (888) 982-7800 for customized products and installation services designed to seal
larger openings.
• Determine whether to install Grommets by screwing the product directly to the floor
with the self-tapping screws or by using the Adhesive Mounting Kit.
• Clean the tile and bottom surface of the KoldLok Extended Raised Floor Grommet using
an alcohol wipe or a clean cotton cloth, damp with a solution of at least 50 percent
isopropyl alcohol. Helpful tip: When choosing your cleaning cloth, do not use fabric or
paper that will disintegrate or leave particles that could interfere with the adhesive.
• The KoldLok Extended Raised Floor Grommet can be modified to fit special situations.
Dimensions and Cutting Requirements Inches (W x D) Millimeters (W x D)
Item No. 10012 3”x 24” - Overall size 24” x 5.05” 610 x 128mm
Maximum cutout size sealed 24” x 4” 610 x 102mm
Usable cable area 22” x 2.5” 559 x 64mm
Product height above the raised floor 1” w/ mounting kit
installed 25mm w/ mounting kit
installed
Item No. 10013 6”x 24” - Overall size 24” x 8.08” 610 x 205mm
Maximum cutout size sealed 24” x 7” 610 x 178mm
Usable cable area 22” x 5.5” 559 x 140mm
Product height above the raised floor 1” w/ mounting kit
installed 25mm w/ mounting kit
installed