Upsite 2040 Surface Mount XLarge Grommet - Manual

Designer & Manufacturer
(888) 982-7800 www.upsite.com
Installation Guide
Surface Mount Raised Floor Grommet
Part Numbers:
Original - 2020
Large - 2030
XLarge - 2040
Original Carton Contains
Original Grommets (10)
Adhesive Mounting Kit (10)
Edge-Mount Foam Strips, 10 Piece Pad (1)
Installation Guide (1)
Large Carton Contains
Original Grommets (10)
Metal Extension Long (10)
Metal Extension Short (10)
Adhesive Mounting Kit (10)
Edge-Mount Foam Strips, 10 Piece Pad (1)
Installation Guide (1)
XLarge Carton Contains
Original Grommets (10)
Metal Extension Long (20)
Adhesive Mounting Kit (10)
Edge-Mount Foam Strips, 10 Piece Pad (1)
Installation Guide (1)
Tools needed:
• Cutting tool (per floor tile manufacturer recommendations)
• Tape measure
• Isopropyl alcohol or equivalent for cleaning
Preparation:
Cutting Raised Floor Tiles
Each raised floor tile manufacturer provides instructions to properly and
safely modify their products. Installers must be familiar with and observe
tile manufacturer’s recommendations with regard to applicable tools, cut-
ting procedures, the design load capacity of the cut tile, and any addi-
tional underfloor supports requirements for cut raised floor tiles.
*IMPORTANT: Data center best practices indicate that tiles should not be
cut within the raised floor environment in order to protect equipment
from harmful particulates. However, quick clean up of any debris or loose
particulates is always recommended.
Clean the tile and bottom surface of the grommet using an alcohol wipe
or a clean cotton cloth, damp with a solution of at least 50 percent iso-
propyl alcohol.
HELPFUL TIP: When choosing your cleaning cloth, do not use fabric or pa-
per that will disintegrate or leave particles that could interfere with the
adhesive or contribute to airborne contamination.
Original 2020 Large 2030 XLarge 2040