Initialization – Teo IP Phone 4101 Installation User Manual
Page 17
Installation
13-280135 Rev. K
Page 17
I
I
n
n
i
i
t
t
i
i
a
a
l
l
i
i
z
z
a
a
t
t
i
i
o
o
n
n
With the application of power, the phone’s operating software is loaded into internal
memory. During this interval, the Message Waiting Indicator will be illuminated. Upon
completion the display will show the model number, followed by the current software
version.
The display will show progress messages while establishing the communication layers.
Many configuration settings can be set automatically by a DHCP server and telephone
update server. DHCP should be used if available; it is enabled by default.
If DHCP and update servers are available and configured properly, the phone will prompt
for a Line ID and SIP Password the first time that the phone is connected to the network.
You may also be prompted for an authentication ID if required by the system.
•
Enter the appropriate Line ID (phone) number, and then press the
ENTER
key. This
would typically be the phone number used for station-to-station calls.
•
If prompted, enter the appropriate authentication ID number, and then press the
ENTER
key. Leave this entry blank if no authentication ID is required.
•
Enter the appropriate password, and then press the
ENTER
key. Leave this entry
blank if no password is required.
•
If the update server protocol and IP address are not supplied by DHCP, configure
these items as shown on the following page.
During the registration process, the following display will be shown.
When the phone is registered with the proxy server, the following status message will be
displayed.
The idle display will then appear, indicating that the phone is ready for use.
SIP REGISTRATION
SUCCESSFUL
SIP REGISTRATION
IN PROGRESS...
SIP PASSWORD=
_
AUTH ID=
_
LINE ID=
_
INITIALIZING...
07.04.16