Teac KS-1017 - Manual (Page 8)

8
Kachinko System
9
Kachinko System
Rear panel
JOINT CN
LINE
MIC MIC
LINE
AUDIO 2 AUDIO 1
There are two identical balanced female XLR-type connectors
used for the input of audio signals to the KS-1018, marked
AUDIO 1 and AUDIO 2. These are wired 1=ground, 2=hot,
3=cold.
Each connector has a mic/line level switch (MIC/LINE), used to
match the input level with the level of the audio sync signal.
There is also a female 15-pin D-sub connector, allowing the
connection of the two balanced audio signals as well as a power
supply. See the specifications for details of how to wire this con-
nector.
Side view
����� �������
������ �������
There is only one control on the left side (as you look from the
front). This is a recessed volume control for the internal speak-
er. Use a small Phillips screwdriver to adjust the volume (clock-
wise to increase the volume, counterclockwise to decrease it).
About the case
Thecarrying case for the KS1018 may hold a few surprises!
The rear flap can be folded back for access to the XLR connec-
tors for the analog inputs, as well as the MIC/LINE switches.