Teac KS-1017 User Manual

Page 4

Kachinko System

The KS-1018 is used to produce a synchronized video and au-
dio signal. See the separate manual for details of operation of

this unit.

Next, at the other end, the KS-1017 is connected to one or two
audio feeds (typically the main and sub audio channels), and

its video probe is used to read the screen showing the “clapper-

board” so that the audio and video signals can be detected.
The KS-1017 then computes the delay between the audio and

the video signals.

The time in milliseconds or frames between these signals is

then read out and the delay adjusted appropriately. Note that
the frame rate (NTSC or PAL/SECAM) is set at the factory and

cannot be changed. The frame rate for the unit is shown on the

front panel.