Teac GRANDIOSO D1 - Manual (Page 15)

15 15
En
gl
is
h
Clock input connector selection
CLKin>***
Use this to select the clock input connector.
CLK
In this mode, this unit can receive a clock signal through its CLOCK
SYNC IN connector from a clock generator and operate with clock
synchronization.
o The input impedance of the CLOCK SYNC IN connector is 75 Ω, so
TTL-level square wave signals can be input.
10M
In this mode, this unit can receive a 10MHz clock signal from a clock
generator connected to its 10MHz IN connector and operate with
clock synchronization.
o The audio source device must also be connected to the clock
generator or be connected to this unit's CLOCK SYNC OUT con-
nector and set to receive clock synchronization.
o The input impedance of the 10MHz IN connector is 50 Ω, so sine
wave signals can be input.
Clock output settings
CLK_TH>***
This sets the clock output during clock input mode.
OFF
No clocks signal is output from the CLOCK SYNC OUT connector.
ON
The input clock signal is output from the CLOCK SYNC OUT connec-
tor as clock with the same frequency.
Playback channel setting
CH>***
This shows the channel played back by this unit.
By default, this is set to “CH> – – –”. Use this setting when only con-
nected to a P1 as a dedicated system.
(Use with ES-LINK or XLR_DUAL connections.)
When connecting to digital input connectors in modes other than
ES-LINK and XLR_DUAL and using the left and right channel transmis-
sion (L-R) connectors or i.LINK connectors, use one of the following
settings.
- - -
The channel used is not set. Only use this when connecting a P1 or
other source device that can output left and right signals as mono.
Using L-R LINK is not necessary.
Lch
Use to play back the left (front left) channel. The right channel data
will be output from the L-R connector.
Rch
Use to play back the right (front right) channel. The right channel
data will be input through the L-R connector.
Cch
Use to play back the center channel. Select this when using i.LINK for
multichannel playback.
SWch
Use to play back the subwoofer channel. Select this when using i.LINK
for multichannel playback.
LSch
Use to play back the left surround channel. Select this when using
i.LINK for multichannel playback.
RSch
Use to play back the right surround channel. Select this when using
i.LINK for multichannel playback.
o When using input other than ES-LINK, DUAL or i.LINK, connect this
unit to the D1 set as the left channel. The various settings made
for the left channel will be reflected by the right channel settings.
o If the audio source device is playing back a two-channel source,
no sound will be output from this unit if this setting is anything
other than Rch or Lch.