Teac US-600 - Manual (Page 11)

TASCAM US-600
11
Rear panel
q
MIC/LINE IN 3/4 (balanced) connectors
Use these connectors as balanced analog
XLR microphone inputs or as standard
TRS balanced analog input jacks.
XLR (1: GND, 2: HOT, 3: COLD)
•
TRS (Tip: HOT, Ring: COLD, Sleeve: GND)
•
w
LINE OUT 1/2 (unbalanced) jacks
These RCA pin jacks are unbalanced
analog line outputs.
These jacks can output signals sent
from the computer via USB, signals
from the built-in monitoring mixer or
a combination of both. Use the US-600
software control panel on the computer
to set which signals are output. Connect
these jacks to recorders, speakers with
built-in amplification and external effect
devices, for example.
NOTE
The •
LINE OUT 1/2 jacks can output the
analog signals input through the unit.
The
•
LEVEL knob, which also controls the
headphone output, can be used to adjust
the output level of the LINE OUT 1/2
jacks.
e
DIGITAL IN (coaxial) jack
This coaxial digital input is compliant
with IEC 60958-3 (S/PDIF) standards.
NOTE
When using this unit’s digital input, the
connected device must become the clock
master. For details, see “Sound module/MD/
CD etc. (digital connection)” on page 23.
r
MIDI IN connector
This 5-PIN DIN is a standard MIDI input
connector for inputting MIDI signals.
t MIDI OUT connector
This 5-PIN DIN is a standard MIDI output
connector for outputting MIDI signals.
y
PHANTOM (+48V) switch
Use this to turn +48V phantom power on
for mic input connectors 1-4.
CAUTION
Always set the
•
PHANTOM (+48V) switch
to OFF before turning the unit’s power on
or off (connecting or disconnecting the AC
adaptor).
Always turn the
•
LEVEL knob to the
minimum volume before changing the
switch between ON and OFF. Depending
on the connected microphone, loud noises
might be produced and damage could be
caused to equipment and people’s hearing.
2 − Names and Functions of Parts