Teac US-800 - Manual (Page 17)

TASCAM US-800
17
Pan sliders
Set the pan for each channel in a range of
L15 - C - R15. When set all the way to the left
(L15), the input signal is sent entirely to the
left channel (0 dB), and no signal is input to
the right channel (–∞). When set all the way
to the right (R15), this is reversed. When pan
is set to center (C), the signal is sent equally
to both left and right channels with a –3 dB
reduction on both sides.
When “Stereo link” is ON, sliders set the
balance between left and right channels (as
the left becomes louder, the right becomes
quieter and vice versa). One slider is shown
for both linked channels.
Input level meters
These show the input levels of each channel.
For input 1-8 signals, the pre-fader levels are
shown. For computer 1-6 signals, the post-
fader levels are shown.
Input faders
Use these faders to adjust the mixer input
levels in a range from –∞ to +6 dB.
NOTE
In the following explanations, the Windows
version of the software is described first. When
the Mac version has a significant difference, it is
described second. Mac version part names are
indicated in parentheses.
SOLO (S) buttons
When a "
SOLO
" button is turned ON, only
channels with "
SOLO
" buttons turned ON
have their signal sent to the stereo bus. All
other channels are muted. When the SOLO
mode is set to “Mix”, SOLO can be turned ON
for multiple channels. If set to “Exclusive”, only
the last channel that was set to SOLO can be
heard.
ON: lit
OFF (default value): unlit
Mute (M) buttons
Use these to mute channels.
ON: lit
OFF (default value): unlit
L (LINK) buttons
Use these stereo link buttons to synchronize
the operation of the left and right channel
faders in a pair.
This also joins the pan sliders into a single
balance slider.
ON: lit
OFF (default value): unlit
Fader level displays
The current level of each fader is shown in
decibels. In the Mac version, if you move a
PAN slider, the pan position (L15 -C - R15) is
shown momentarily instead.
Master fader section
ª
Windows Mac
Master fader
The stereo master faders include a fader for
both left and right channels. If the stereo link
is disabled, moving these faders separately is
possible.
Mute (M) buttons
Use these to mute channels.
ON: lit
OFF (default value): unlit
4 – US-800 control panel settings