Teac MX-2424 Quick Reference Guide - Manual

Load
Delete
Rename
Smart Copy
TapeMode Convert
Convert/Copy Abort
PROJECT ARROW KEYS
YES
THE PROJECT KEY
SHIFT
Press PROJ once to access
these Project level functions.
1
Press PROJ again (or YES) to activate
the desired function.
3
2 Use the Arrow Keys to select the function.
4 Use the Arrow Keys to select a source Project
then press YES to complete the selection.
If a project of the same name exists on more than
one drive attached to the MX-2424 the SCSI ID #
of the drives will be displayed in the LCD.
LOAD
This function loads the selected project from a hard
drive into the MX-2424. Any currently open project will
be automatically closed.
DELETE
This function deletes the selected project from the
MX-2424's file directory. To recover the drive space
it will be necessary to use the Disk Cleanup function
in Menu 720.
RENAME
This function will rename the selected project.
SMART COPY
This function is used to backup, restore and copy
projects from one drive to another.
TAPEMODE CONVERT
This function will make a TapeMode copy of a selected
project creating a single contiguous audio file per track.
CONVERT/COPY ABORT
This command will abort and Smart Copy or TapeMode
Convert operation in progress.
5 The MX-2424 will prompt for the SCSI ID number
of the destination drive. Press the TRIM key then
use the Arrow keys to change the selected SCSI device.
Press YES to confirm the selection.
6 A new name may then be entered for the destination
project by pressing TRIM, using the Shuttle Wheel to
move the cursor and the Arrow Keys to change the
character. Press YES to confirm a new or existing
project name.
TRIM KEY
7 "Are you sure (y/n)?" Press YES to complete the
operation or NO to abort.
Use of LOAD, DELETE, or RENAME will only require steps
1 through 4.
Use of SMART COPY or TAPEMODE CONVERT
will additionally require steps 5 through 7.
TO CREATE A NEW PROJECT
1 I f more than one hard drive is attached to the MX-2424 press
SETUP, then the numerical key "7", then the Up arrow key to access
Menu 701.
2 Press TRIM and use the Arrow keys to select the SCSI ID number of the
drive that will contain the new project. Press YES to confirm the selection.
Proceed to Step #3.
3 If the MX-2424 has only one hard drive attached
press SHIFT then PROJ to directly access Menu 800.
4 Use the SHTL ring to move the cursor and the UP/DOWN Arrow keys
to change the character to enter the desired new project name.
5 Press YES to confirm.
T
ASCAM MX-2424 QUICK REFERENCE GUIDE
More Than
1 Drive
Internal
Drive Only