Teac UD-301 - Manual (Page 2)

2
CAUTION: TO REDUCE THE RISK OF
ELECTRIC SHOCK, DO NOT REMOVE COVER
(OR BACK) . NO USER-SERVICEABLE PARTS
INSIDE . REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL .
<
The lightning flash with arrowhead
symbol, within an equilateral trian-
gle, is intended to alert the user to
the presence of uninsulated “dan-
gerous voltage” within the product’s
enclosure that may be of sufficient
magnitude to constitute a risk of elec-
tric shock to persons .
B
The exclamation point within an equi-
lateral triangle is intended to alert
the user to the presence of impor-
tant operating and maintenance
(servicing) instructions in the litera-
ture accompanying the appliance .
WARNING: TO PREVENT FIRE
OR SHOCK HAZARD, DO NOT
EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE .
CAUTION
o DO NOT REMOVE THE EXTERNAL CASES OR
CABINETS TO EXPOSE THE ELECTRONICS . NO
USER SERVICEABLE PARTS ARE INSIDE .
o IF YOU ARE EXPERIENCING PROBLEMS WITH THIS
PRODUCT, CONTACT THE STORE WHERE YOU
PURCHASED THE UNIT FOR A SERVICE REFERRAL .
DO NOT USE THE PRODUCT UNTIL IT HAS BEEN
REPAIRED .
o USE OF CONTROLS OR ADJUSTMENTS OR
PERFORMANCE OF PROCEDURES OTHER THAN
THOSE SPECIFIED HEREIN MAY RESULT IN
HAZARDOUS RADIATION EXPOSURE .
IN USA/CANADA, USE ONLY ON 120 V SUPPLY.
Model for USA
This device complies with part 15 of the FCC
Rules . Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation .
CAUTION
Changes or modifications to this equipment not
expressly approved by TEAC CORPORATION for
compliance will void the user’s warranty .
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules .
These limits are designed to provide reason-
able protection against harmful interference in a
residential installation . This equipment generates,
uses, and can radiate radio frequency energy
and, if not installed and used in accordance with
the instructions, may cause harmful interfer-
ence to radio communications . However, there
is no guarantee that interference will not occur
in a particular installation . If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is encour-
aged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the equipment and/or the
receiving antenna .
• Increase the separation between the equip-
ment and receiver .
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected .
• Consult the dealer or an experienced radio/TV
technician for help .
Model for Canada
Industry Canada’s Compliance Statement:
This Class B digital apparatus complies with
Canadian ICES-003 .
Cet appareil numérique de la classe B est conforme
à la norme NMB-003 du Canada .
IMPORTANT SAFETY INSTRUCTIONS