Sundance SMT363XC2 - Manual (Page 18)

Version 2.2 Page 18 of 27 SMT363XC2 User Manual
Code Composer
This module is fully compatible with the Code Composer Studio debug and
development environment. This extends to both the software and JTAG debugging
hardware. The driver to use is the tixds6x1x_11.dvr. CCS version 3.0 or later is
required as the reprogramming utility (SMT6001) requires it.
Troubleshooting
Our Knowledge data base and FAQ sections may help you to resolve some known
issues.
Application Development
Depending on the complexity of your application, you can develop code for
SMT363XC2 modules in several ways.
SMT6400
For simple applications, the Sundance
SMT6400 software support package (project
examples) and its associated header files (SmtTim.h and ModSup.h) can suffice.
The SMT6400 product is installed by the Sundance Wizard and it is free of charge.
SMT6060
SMT6060-FTP is a utility that allows and easy and cost-effective integration of the Net+50 ARM chip
and the DSP that can be found on SMT363. It is ready to use and provide a TCI/IP interface to a host .
SMT6060-TCPIP is a software package that provides Ethernet connectivity via the industry standard
Berkeley sockets interface to a 3L/Diamond network of DSP processors. The package is typically used
when there is at least one SMT363 present in the system; however, using a feature of the SMT6025
software package, it also provides seamless connectivity via the HOST PC’s (Winsock 2.2) Ethernet
hardware. The software is ready-to-use and provides sockets connectivity to any Sundance DSP
processor.
3L Diamond
This module is fully supported by 3L Diamond, which Sundance recommends for all
but the simplest of applications. An SMT363XC2 has to be declared as appropriate in
configuration files as one processors of type:
• SMT363XC2_1 (16MB SDRAM)
• SMT363XC2_2 (64MB SDRAM)
SMT6500
This is the
support package for the FPGA . It may be used to develop your application
in the FPGA of the module.