Setting up code composer version 4.3 – Sundance SMT6012 v.4.6 User Manual

Page 18

Version 4.6

Page 18 of 22

SMT6012 User Manual

• The selected driver should now be displayed in the "Available Board/Simulator

Types" panel. Click and drag it into the "System Configuration" panel. This
triggers the "Board Properties" window to come up.

• Click on Next. Enter the I/O Port value for your Sundance carrier board. (As

obtained using the SMTBoardInfo.exe application). Click Next.

• You now must enter the number of processors plugged into the Sundance

carrier board as well as any devices to bypass (if there are any). Once done
click Finish.

• Code Composer Studio is now ready to use. Save and exit the setup.

5.6 Setting up Code Composer version 4.3

• Select the relevant CC driver files from the driver directory as described in the

table below and copy them into the CC directory.

Board

On-board - C4x

Off-board – C4x

On-board - C62

Off-board – C62

SMT310

SMT310C4xOn.dll SMT310C4xOff.dll Not supported

Not supported

SMT310Q

Not supported

SMT320-V4

SMT320C4xOn.dll SMT320C4xOff.dll SMT320C62Off.dll SMT320C62On.dll

SMT320-V3

SMT320C4xOn.dll SMT320C4xOff.dll SMT320C62On.dll SMT320C62Off.dll

Table 5 – CC 4.3 Driver selection

• Open CC Set-up.
• In the General Tab, click "Add Driver" and select the relevant driver file.
• Still in the General Tab, enter the I/O Port address for your Sundance carrier

board as obtained using the SMTBoardInfo.exe application.

• Next click the "Multi-processor" tab. Declare each C4x processor by entering a

suitable unique processor name, for instance, 'p1', (Take care not to use any
capital letters in the name), then click "Insert". This adds the processor in the
Processor List.

• Click OK twice to exit CC Setup.
• CC is now ready to use.