Sundance SMT6012 v.4.6 - Manual (Page 13)

Version 4.6 Page 13 of 22 SMT6012 User Manual
Figure 7 - Specifying the GEL file
• If you are using a GEL file, you can specify it at this stage.
• Click on “Finish”
• Save and exit the CCS 2.x setup program.
• You are now ready to run CCS 2.x
Note that If you are using multiple independent boards (i.e. boards that are not
connected via the JTAG chain) you should have a board entry for each of the boards.
This is not possible in CCS 1.2 to specify 2 independent boards, and you will have to
use CCS 2.x to accomplish this.
You can add more carrier boards to the system by repeating the procedure outlined
above. For each board you add, specify a unique board name.
The figure below shows the configuration for CCS 2.x for multiple independent
boards.
User Manual (QCF42); Version 4.6, 26/06/02; © Sundance Multiprocessor Technology Ltd. 2002