Sundance SMT6012 v.4.6 - Manual (Page 17)

Version 4.6 Page 17 of 22 SMT6012 User Manual
For Windows 95/98
• Add the following entries in your “Autoexec.bat” file.
SET UNIFY_PODDRVR_E = DLLNAME
SET UNIFY_PODPORT_E = ADDRESS
• Where DLLNAME is the driver DLL name as described in the table below. For
example, SMT310On12.DLL. ADDRESS is the I/O base address returned by
the SMTBoardInfo.exe program. For example “0x2000”
Board On-board Off-board
SMT310 SMT310On12.dll SMT310Off12.dll
SMT310Q SMT310On12.dll SMT310On12.dll
SMT320-V4 SMT320On12.dll SMT320Off12.dll
SMT320-V3 SMT320On12.dll SMT320Off12.dll
Table 3 - CCS1.2 Driver selection
• You are now ready to run CCS 1.2.
• Note: It is not possible to configure CCS 1.2 to use two or more independent
carrier boards. If this is your requirement, then use CCS 2.0.
5.5 Setting up Code Composer Studio version 1.0
• Open CCS Setup.
• Click on "Install Device Driver" and Browse to the directory where the
SMT6012 is installed. Refer to the table below to select the relevant driver file
for your board.
Board On-board Off-board
SMT310 SMT310C6xOn.drv SMT310C6xOff.drv
SMT310Q SMT310C6xOn.drv SMT310C6xOn.drv
SMT320-V4 SMT320C6xOff.drv SMT320C6xOn.drv
SMT320-V3 SMT320C6xOn.drv SMT320C6xOff.drv
User Manual (QCF42); Version 4.6, 26/06/02; © Sundance Multiprocessor Technology Ltd. 2002
Table 4 - CCS1 Driver selection