Studio Technologies 55 2002 - Manual (Page 21)

Model 55/56 User Guide Issue 4, June 2002
Studio Technologies, Inc. Page 21
Model 56 Configuration Chart—Main Functions
Press a Communications
button to toggle between
latching or momentary
operation; LED on means
the button is set to latch
Press CR 1 through 4 to
toggle each channel’s input
sensitivity between
–10dBV and +4dBu; LED on
means input is set to +4dBu
Press and hold
Configure for two seconds to enter
or exit the configure mode; while in
configure, LED will flash
Press and hold Dub, then press CR 2
through 4 to select a dim level:
LED 2 is 25dB
LED 3 is 20dB
LED 4 is 15dB
Press and hold Dub, then
press CR 1 to toggle the
dub output between
–10dBV and +4dBu; LED
on means dub is set to
+4dBu
Press and hold Phones, then
press CR 1 through 4 to toggle
the inputs between stereo and
mono operation; LED on means
input is set to mono
Press and hold
Dub and Phones
for 2 seconds
to reset all
parameters to
factory defaults
Press Mono to toggle
between latching or
momentary operation;
LED on means the
Mono button is set
to latch
Press Dim to toggle
the automatic dim
off function; LED on
means auto dim
off function is active
Press and hold Level
Up to activate alternate
configure functions
(refer to next page)