Studio Technologies 55 2002 - Manual (Page 17)

Model 55/56 User Guide Issue 4, June 2002
Studio Technologies, Inc. Page 17
a standard 3-conductor microphone-type
cable. For best performance, use low-
capacitance shielded cable.
The Model 70 provides independent left
and right balanced outputs. Pin 1 is shield,
pin 2 is signal positive (+ or hot), and pin 3
is signal negative (– or cold). The electroni-
cally balanced outputs have a nominal
signal level of +4dBu and are capable of
driving loads of 600 ohms or greater.
The Model 70 can be used by itself, or in
conjunction with up to four Model 35 or
Model 38 Talent Amplifiers. The loop
through connector on the Model 70 can
be used to connect to a Model 35 or 38
Talent Amplifier.
Configuration
Many StudioComm functions can be
configured to meet the exact needs of your
installation. Here’s an overview of what
you can configure:
• –10dBV or +4dBu sensitivity for each
input
• Stereo or mono for each input
• –10dBV or +4dBu level for the dub
output
• Dim level
• Momentary or latching operation for
mono, talk to phones, and slate buttons
• Auto dim off function
• Slate feed to phones
• Talk to phones interrupts or adds to
phones source
• Allow simultaneous selection of two
control room sources
The Configure button allows the Model 56
to go into the configure mode. While in the
configure mode, all the Model 56’s buttons
and LEDs are associated with configure
functions. Refer to the Model 56 Configu-
ration Chart later in this section.
To enter the configure mode, press and
hold the Configure button for two seconds.
While in the configure mode, all audio
outputs switch off and the orange LED
beside the Configure button will flash. As
you make changes, the Model 56 keeps
track of the new settings and updates the
system when you exit the configure mode.
You must exit the configure mode before
any changes take effect.
Model 70 Front Panel
Model 70 Back Panel