Studio Technologies 55 2005 - Manual (Page 18)

Issue 5, August 2005 Model 55/56 User Guide
Page 18 Studio Technologies, Inc.
Reset Factory Defaults
Provision has been made to allow you to
return all confi gurable parameters to the
factory default values. With the Model 56
in the confi gure mode, press and hold both the Dub and Phones buttons. After two
seconds the factory defaults will be stored
in memory, the confi gure mode will auto-
matically end, and the Model 56 will return
to normal operation.
Model 56 Confi guration Chart—Main Functions
Press a Communications
button to toggle between
latching or momentary
operation; LED on means
the button is set to latch
Press CR 1 through 4 to
toggle each channel’s input
sensitivity between –10 dBV
and +4 dBu; LED on means
input is set to +4 dBu
Press and hold
Confi gure for two seconds to enter
or exit the confi gure mode; while in
confi gure, LED will fl ash
Press and hold Dub, then press CR 2
through 4 to select a dim level:
LED 2 is 25 dB
LED 3 is 20 dB
LED 4 is 15 dB
Press and hold Dub, then
press CR 1 to toggle the
dub output between –10
dBV and +4 dBu; LED on
means dub is set to +4 dBu
Press and hold Phones, then
press CR 1 through 4 to toggle
the inputs between stereo and
mono operation; LED on means
input is set to mono
Press and hold
Dub and Phones
for 2 seconds
to reset all
parameters to
factory defaults
Press Mono to toggle
between latching or
momentary operation;
LED on means the
Mono button is set
to latch
Press Dim to toggle
the automatic dim
off function; LED on
means auto dim
off function is active
Press and hold Level
Up to activate alternate
confi gure functions
(refer to next page)