Studio Technologies 55 2005 - Manual (Page 15)

Model 55/56 User Guide Issue 5, August 2005
Studio Technologies, Inc. Page 15
Installation is very simple. Connect
the Model 70 to the Model 55 Central
Controller’s talent amplifi er output using
a standard 3-conductor microphone-type
cable. For best performance, use low-
capacitance shielded cable.
The Model 70 provides independent left
and right balanced outputs. Pin 1 is shield,
pin 2 is signal positive (+ or hot), and pin
3 is signal negative (– or cold). The elec-
tronically balanced outputs have a nominal
signal level of +4 dBu and are capable of
driving loads of 600 ohms or greater.
The Model 70 can be used by itself, or
in conjunction with up to four Model 35
Talent Amplifi ers. The loop through con-
nector on the Model 70 can be used to
connect to a Model 35 Talent Amplifi er.
Confi guration
Many StudioComm functions can be con-
fi gured to meet the exact needs of your
installation. Here’s an overview of what
you can confi gure:
• –10 dBV or +4 dBu sensitivity for each
input
• Stereo or mono for each input
• –10 dBV or +4 dBu level for the dub
output
• Dim level
• Momentary or latching operation for
mono, talk to phones, and slate buttons
• Auto dim off function
• Slate feed to phones
• Talk to phones interrupts or adds to
phones source
• Allow simultaneous selection of two
control room sources
The Confi gure button allows the Model 56
to go into the confi gure mode. While in the
confi gure mode, all the Model 56’s buttons
and LEDs are associated with confi gure
functions. Refer to the Model 56 Confi gu-
ration Chart later in this section.
To enter the confi gure mode, press and
hold the Confi gure button for two seconds.
While in the confi gure mode, all audio
outputs switch off and the orange LED
beside the Confi gure button will fl ash. As
you make changes, the Model 56 keeps
track of the new settings and updates the
system when you exit the confi gure mode.
You must exit the confi gure mode before
any changes take effect.
Model 70 Front Panel
Model 70 Back Panel