Studio Technologies 76DBA V.3.00 - Manual (Page 36)

Issue 1, November 2010 Model 76DBA/77B User Guide
Page 36 Studio Technologies, Inc.
for Surround
Press and hold both the Dialnorm Enable and Dim buttons for 5 seconds to restore Model 77B
factory defaults. Once defaults have been restored, the associated LEDs will light. After the
buttons are released, configuration mode will be exited and normal operation will resume.
Configuration—Restore Factory Defaults
Warning: Each Model 77B unit must have a unique address. Restoring factory defaults will reset only this specific
Model 77B to address A1. If another connected unit is already configured for address A1, normal system
operation will stop.
Note: The 5-second button-press delay is a safety feature ensuring that the factory defaults will not be accidently
restored.

Factory Defaults:
Device address A1.
Stereo input C sample rate converter enabled.
0 dB auxiliary stereo digital and analog monitor output
nominal level.
Sync source is L/R of currently selected input.
Sync input terminated.
Audio-synced-to-video sample rate 48 kHz.
Pre-fader surround/stereo input C direct digital monitor
output type AES3 (110 ohms/5 Vpp).
Post-fader surround/auxiliary stereo digital monitor output
type AES3 (110 ohms/5 Vpp).
Surround input A assigned to input 1.
Surround input B assigned to input 2.
No input assigned to input 3 (disabled).
Stereo input A assigned to input 4.
Stereo input B assigned to input 5.
Stereo input C assigned to input 6.
–60.0 dB post-fader surround digital and analog
reference output level.
Attenuation display mode selected.
85.0 dB SPL reference level.
–31 dB dialnorm reference level.
Dialnorm data assigned to surround input A.
–20 dB dim level.
Remote mute all enabled.
Remote dim enabled.
Remote auxiliary stereo digital and analog monitor output
on/off enabled.
Input delay 0 ms.
6.0 dB channel pop solo up offset level.
–6.0 dB channel pop solo down offset level.
LFE downmix disabled.
Pre-fader surround digital monitor outputs pre-downmix.