Studio Technologies 76DBA V.3.00 - Manual (Page 35)

Model 76DBA/77B User Guide Issue 1, November 2010
Studio Technologies, Inc. Page 35
for Surround
Configuration—Channel Pop Solo Mode Offset Levels, LFE
Downmix Mode, and Pre-Fader Surround Digital Monitor Output
Mode
Default: 6.0 dB channel pop solo up offset level.
–6.0 dB channel pop solo down offset level.
LFE downmix disabled.
Pre-fader surround digital monitor output pre-downmix.
Press and hold the
5.1 to Stereo but-
ton to display and
select the channel
pop solo up offset
level, to configure
LFE downmix, and
configure pre-fader
surround digital
monitor output
mode.

When the 5.1 to Stereo button is pressed, use the level
control to adjust the channel pop solo up offset level.
The range is 0.0 to 12.0 in 0.5-dB steps.
When the Stereo to Mono button is pressed, use the level
control to adjust the channel pop solo down offset level.
The range is –0.0 to –12.0 in 0.5-dB steps and full mute.
Full mute is selected by adjusting the level control past
–12.0, at which point the display will show – – – –.
Press and hold the
Stereo to Mono
button to display
and select the
channel pop solo
down offset level.

When the 5.1 to Stereo button is pressed,
this LED displays the configuration of the
LFE downmix mode. LED not lit means
LFE downmix mode is disabled; LED lit
means enabled. Use the button to change
the configuration. When the 5.1 to Stereo button is pressed, these
LEDs display the configuration of the pre-fader
surround digital monitor output mode. LED
L lit means outputs are pre-downmix; LED R lit
means outputs are post-downmix. Use the but-
tons to change the configuration.