Studio Technologies 76D V.2.02 - Manual (Page 30)

Issue 2, June 2009 Model 76D/77 User Guide
Page 30 Studio Technologies, Inc.
for Surround
Press and hold both the Surround/Stereo and Dim buttons for 5 seconds
to restore Model 77 factory defaults. Once defaults have been restored,
the associated LEDs will light. After the buttons are released, configura-
tion mode will be exited and normal operation will resume.
Configuration—Restore Factory Defaults
Factory Defaults:
Device address A1.
Stereo input C sample rate converter enabled.
Post-fader stereo output can be enabled.
Sync type video.
Sync input terminated.
Audio-synced-to-video sample rate 48 kHz.
Pre-fader surround/stereo input C direct monitor output
type AES3 (110 ohms/5 Vpp).
Post-fader surround/stereo monitor output type
AES3 (110 ohms/5 Vpp).
Reference level set for –60.0 dB post-fader monitor
output level.

Warning: Each Model 77 unit must have a unique address. Restoring factory defaults will reset only this specific
Model 77 to device address A1. If another connected unit is already configured for address A1, normal system
operation will stop.
Note: The 5-second button-press delay is a safety feature ensuring that the factory defaults will not be accidently
restored.
Attenuation display mode selected.
85.0 dB SPL reference level.
Auto reference level off disabled.
–20 dB dim level.
Remote mute all enabled.
Remote dim enabled.
Input delay 0 ms.
LFE downmix disabled.
Pre-fader surround monitor outputs pre-downmix.
6.0 dB channel pop solo up offset level.
–6.0 dB channel pop solo down offset level.