Space Ray RSTP Series - Manual (Page 33)

Form 43206000
-32- Sept 2011
21.0)
REPLACING PARTS
ELECTRIC SHOCK & EXPLOSION HAZARD
Disconnect electrical power and gas supply before
servicing.
Failure to do so may result in death or serious injury.
Only use genuine Space-Ray replacement parts. Parts are available from the factory for replacement by a
licensed person. Refer to the Replacement Parts Guide in Section 23.0) for all replacement parts.
21.1)
REMOVAL OF SPARK ELECTRODE AND FLAME SENSOR
1
2
2
3/16”
3
4
5
Spark Electrode
Flame Sensor
1.
Disconnect electrical supply, open access panel.
2. Remove two mounting screws for each and take out the spark electrode and flame sensor.
3. Check that the spark gap is 3/16”.
4. Check spark electrode and flame sensor. The rods should be clean and free from debris.
5. Check ceramic on the spark electrode and flame sensor. It should be free from cracks.