Space Ray RSTP Series User Manual

Page 12

Form 43206000
Sept 2011

-11-

Install the suspension chains (according to Section 7.0) using proper suspension method (see Section 9.0).

chains for suspension

109-1/2

Hooks rated

@ 115lbs min.

Turnbuckle rated

@ 230lbs min.

Chain rated

@ 230lbs min.

109-1/2

Suspension

Chain

Chain rated

@ 115lbs min.

Hooks rated

@ 115lbs min.

Trapeze Method

Individual Suspension Method

Lift the heater and suspend it into place. When lifting, caution should be used to avoid damaging the

assembly. Make sure that the long axis of heater is level.

Level indicator

The long axis of heater

Side View

If the heater is to be used Indoors and Vented

Indoors and Vented

Indoors and Vented to the outside, install the flue collar supplied with the heater

by placing the collar directly over the gasket. Secure the collar flange with clamps. See Figure 4 on next
page.

Attach a 6” diameter flue pipe to the flue collar. Place an approved vent cap to the outside end of the flue

pipe. See Section 14.0) for flue vent requirements.

If the heater is to be used Indo

Indo

Indoors and Unvented

ors and Unvented

ors and Unvented, order the Indoor Unvented Kit (Part #42406000). Remove

the clamps and install the Exhaust Hood directly over the gasket. See Figure 5 on next page.

If the heater is to be used Outdoors

Outdoors

Outdoors, order the Outdoor Kit (Part #42411000). Install the Exhaust Hood as

instructed above in #4. Remove the solid cover panel from the side and install the Inlet Air Hood. Remove
the perforated cover panel from the top and replace it with the solid cover panel. See Figure 5 on next page.
After completing the assembly, silicone sealant should be utilized to seal the access panel openings. If the
installation site is subject to excessive wind conditions, it might be necessary to utilize pop rivets to secure
the reflectors to the heater body.