SoundTraxx Coach Lighting Decoder Users Guide - Manual (Page 25)

SoundTraxx Lighting Decoder User’s Guide Page 22
Troubleshooting
If you should have any difficulties with the operation of your SoundTraxx
Lighting Decoder, first check this section for hints on trouble shooting. We
have found that most problems are caused by an errant CV value and are
easily corrected. When all else fails, try resetting the CV values back to their
defaults (see the section ‘Basic Programming’) and try again.
Lights flicker on and off
Decoder is in 14 speed step mode and command station is set to 28
speed steps.
Lights do not work
Decoder is in 28/128 speed step mode and command station is set
to 14 speed steps.
Function mapping is improperly set.
Burned out light bulbs.
If using 1.5 volt micro-bulbs, resistor value is too large.
Broken lamp wires.
If you are still having difficulties, contact our customer service department for
guidance.
SoundTraxx Service Department
210 Rock Point Drive
Durango, CO 81301
Telephone (970) 259-0690
Fax (970) 259-0691
Email: [email protected]
Troubleshooting