SONOSAX SX-R4 (Firmware v3.1) - Manual (Page 34)

User manual SONOSAX SX-R4 Page 34 of 53
5.8.4 INPUT SOURCE
SETUP > INPUT SOURCE
This menu is used to choose and select which input source will be applied to the channels 1-2, 3-4 and 5-6
For the channels 1-2 and 3-4, the possible sources are:
•
AES
•
MIC/LINE
For the channels 5-6, the possible sources are:
•
AES
•
LINE connected on the STEREO IN input
5.8.5 TIMECODE
SETUP > TIMECODE SETTINGS > SOURCE
The SX-R4 can either receive or generate a TimeCode. This menu lets you choose between an external
Timecode source or its own internal Timecode generator its working mode as described below.
•
External Jam Sync
•
External No Jam
•
Internal the TC is generated but its output is disabled on the Lemo 5 pin connector
•
Internal Output the TC is generated and is available on the Lemo 5 pin connector
NOTE: while selecting "Internal Output", then a frame rate other than "Autodetect" must be
selected in the TimeCode Input Format menu. If "Autodetect" is selected, then a warning
will be posted on the screen
NOTE: while in PLAYER mode, if "Internal Output" is selected, then the TimeCode at the output is
the Timecode of the played file
SETUP > TIMECODE SETTINGS > INPUT FORMAT
The SX-R4 can automatically detect the Timecode format applied at the input of the TC connector. However,
to be sure to use the correct format, it is possible to specify its value. In this case, the detection of a format
different from that specified, or not within the tolerances of a standard TimeCode signal, will trigger an alarm.
The different Timecode formats are:
•
Autodetect
•
23.976
•
24
•
25
•
29.97 Non Drop
•
29.97 Drop
•
30 Non Drop
•
30 Drop