SONOSAX SX-R4 (Firmware v3.1) User Manual
Page 20

User manual
SONOSAX SX-R4
Page 20 of 53
5.4 MONITORING
This Monitoring page is used to configure and mix the 10 tracks of the SX-R4 for it's headphone output.
The configuration of the monitoring is done by means of a specific menu as shown below :
The Monitoring is always configured per pair of tracks (10 tracks = 5 pairs of tracks).
The table below shows the available choices and their respective monitoring results on the stereo headphone
output for the pair of tracks 1 and 2:
Monitoring Mode
Result on the Left channel
Result on the Right channel
---
---
---
MONO
1 + 2
1 + 2
STEREO
1
2
REV STEREO
2
1
MS
1 + 2
1 – 2
MONO L
1 + 2
---
MONO R
---
1 + 2
The table below descibes the actions of the Joystick :
Joystick
Short pressure
Long pressure
LEFT, RIGHT
Change the monitoring mode
UP, DOWN
Move the selector
CENTER
Save the modifications and
return to the previous Menu
NOTE:
If a pair of tracks is not activated (not assigned) the only possible value is : " --- " (No
Monitoring)