SONOSAX SX-62R Quick_Start - Manual (Page 3)

SONOSAX SX62R Quick Start Guide Page 3 of 34
1. POWERING THE SX62R
The SONOSAX SX62R can be powered either by:
- 4x internal rechargeable batteries ( 4x D Cells ); depending on the configuration and settings the running
time will be approx 4 to 5 hours with 10'000mAh NiMh cells.
- any regulated DC power supply from 6 to 18Volts, connected on the Hirose4: Pin 1 = Gnd / Pin 4 = +VDC
WARNING: Using dry cells such as alkaline batteries can lead to unexpected powering off or malfunctions
of the unit; use them with caution and only when no NiMh batteries are available;
replace alkaline batteries after 2 hours of use.
1.1 SWITCHING ON
Press [F2] and simultaneously push the toggle switch to [REC] to power on the SX62R. A boot up screen
appears as illustrated below.
If the working day has changed while powering
up the unit, the system asks to confirm the date
of the new working day. This allows keeping the
date of the current working days if the on going
production works is passing across midnight.
Press [OK] to confirm the new working day
Press [CANCEL] to keep the current working day
When one of the key is pressed, the unit will
continue the booting procedure; wait a few
seconds until the main screen appears