SONOSAX SX-62R Quick_Start - Manual (Page 13)

SONOSAX SX62R Quick Start Guide Page 13 of 34
4.4.2 BOOM Output configuration
The [BOOM] output is on the XLR-6 at the rear of the SX62R. This connector sends the output of the
secondary monitor selector to the Boom operator or to any other destination such as the video room, to the
producer etc. The [BOOM] connector also has a microphone input [MIC PL] - with 48V Phantom power – for
the communication's return on the private line; activated by the [COM] key.
When the secondary monitor selector is set to [REC] the modulation sent to the [BOOM] outputs corresponds
to the selection of the recorder's tracks as set in this menu.
The tracks can be configured either as stereo pairs, or individually as a mono track. Tracks 1 to 8 are the
tracks on the Hard disk, A & B are the two tracks of the CF Card
- A primary "switch" toggles the different monitoring modes for pairs 1-2, 3-4 or 5-6: OFF – MONO – STEREO
– REVERSE STEREO – MS – OFF.
- Two secondary "switches" freely assigns each tracks of the pair to the Left or Right channel of the secondary
monitor output: OFF (–) ; Left [L] ; Right [R] ; Centre [C] (equal volume on Left and Right); when the tracks are
individually assigned the primary switch posts "USER".
- The first column of switched toggles the secondary monitoring to SOLO MONITORING mode.
The first row toggle the
SOLO MONITORING
Primary switches select the
monitoring mode per pair:
OFF, MONO, STEREO, REV-
ST , MS or indicates USER
Odd track of the pair
Secondary switches route each
track individually:
OFF – L – R – C
Even track of the pair
Return to previous Menu
4 preset keys to store and
recall user's selections **
** Press 2 seconds on a preset key to store the configuration as it appears on screen
SOLO MONITORING MODE
Touching a key in the first row on the BOOM Output page activates the SOLO MONITORING mode; use this
page to temporarily listen in SOLO mode any individual track, or pair(s) of track(s) or any combination.
Enable / disable the pair,
It's monitoring mode is as
configured in the BOOM Output
page ( Non exclusive selection )
Second row:
Enable / disable the pair and
toggles its listening mode:
Odd– Even– Stereo – MS –
OFF
( Non exclusive selection )
3rd and 4th row:
Select each track individually in
exclusive mode, all other tracks
are muted
Return to BOOM Output page,
the monitoring is resettled in its
original configuration
No Preset in Solo Monitoring
mode